draw straight line in 3d paint

Download Article

Download Article

If you lot want to pigment a crisp, directly line, the good news is you don't have to practise it freehand. Betwixt painter's tape, angled brushes, and paint edgers, y'all have a few unlike options to assist you paint perfect direct lines. We'll walk you lot through your different options pace-by-step below!

1. 1

   Use a ruler and pencil to mark where the line will be, if necessary. For example, if you're trying to paint stripes on a wall, y'all'll need to marker on the wall where you want them to be before attempting to paint them. Position the ruler where you want your line to be, and then run the pencil along the ruler to mark information technology on the wall. Repeat this process, marking 12 inches (30 cm) at a time, until you've marked off the entire length of the line you desire to paint along.^[one]

   • Use a chimera level every bit you get to make sure the lines you're drawing are perfectly straight. Place the level along the line; if the bubble goes to the center of the level, between the 2 black lines, your line is straight.
   • If you're trying to pigment forth the line where your walls and ceiling meet, yous can skip this step.

2. 2

   Pigment the ceiling or above the line you drew outset. It's ok if some of the pigment goes beneath the line or gets onto the wall, as long as you're notwithstanding able to make out where the line is. If painting over the line causes you to non be able to see it, opt instead to paint every bit close to the line as possible without going over it.^[2]

   • If you're painting the ceiling, place a tarp or a drop cloth on the floor below the area y'all'll be working in to catch whatever pigment drops that fall from the ceiling.

   Advertisement

3. three

   Let this pigment dry, and so put painter'southward tape along the line or on the ceiling. Yous'll desire the paint to be completely dry out so that the tape will adhere to it. Place the tape along the line on the painted side of the line or along the very edge of the ceiling where information technology meets the wall.^[3]

   • Information technology will probably take 6-viii hours for the paint to adequately dry.

4. 4

   Paint along the edge of the tape with the paint you used to a higher place the line. This is especially important for painting on textured surfaces, since the paint will seep nether the small cracks that are left in the record and blend in with the paint that'due south already there. Yous only need to pigment a narrow line about 0.5 to 1 inch (1.iii to 2.5 cm) broad along the "bottom" edge of the tape.^[4]

   • Don't worry about the paint going below the line or on the wall; you'll be able to paint over information technology afterward.

5. v

   Let the paint dry, then paint along the reverse side of the line. Requite the paint roughly 6-eight hours to dry. Then, pigment the wall or the area below the line a carve up color. Extend this pigment all the way up to and on superlative of the painter'due south tape without going over information technology.^[5]

6. vi

   Remove the painter'southward tape one time the paint has dried. Later most half-dozen-eight hours, the paint should be stale and you should be able to remove the tape. Pull the record straight dorsum on itself to peel it off, pulling at a irksome and even footstep. This should reveal a directly line separating 2 different colors on your wall, or a wall that is painted a different colour than your ceiling.^[6]

   • If there are whatever leaks or uneven spots in your line, apply a tiny paint brush to bear on them up.

   Advertising

1. ane

   Mark where the line volition be with a pencil and ruler, if necessary. This is especially important if yous're trying to paint stripes on a wall, since you lot'll need to visibly marking where you want them to be before you try to pigment them. Identify the ruler where you want your line to be and run the pencil along information technology to draw the line. Repeat this process, drawing 12 inches (thirty cm) of the line at a time, until y'all've marked off the entire length of the line you desire to pigment along.^[7]

   • You don't need to do this if there'due south already a "natural" line yous'll be painting along, such as where the wall meets the ceiling.
   • Use a chimera level equally y'all get to brand sure you're cartoon a perfectly straight line. Lay the level forth the line that y'all drew; if the bubble goes in between the 2 black lines in the heart of the level, your line is direct.

2. 2

   Make sure yous have a small castor with a pronounced bending. The brush should be small and easily handled, with bristles that are about 1 to ii inches (2.5 to 5.i cm) long. Information technology should also take as sharp an angle as you tin can find. The more pronounced the angle, the easier information technology volition be to paint a directly line.^[viii]

   • Y'all can buy angled pigment brushes anywhere that regular pigment brushes are sold.

3. 3

   Paint a line 0.25 inches (0.64 cm) below or away from the line. Dip just the tips of the brush bristles into your paint, so spread information technology in one polish motility below the line. Try to make your painted line even with the marked line, although it won't exist a big deal if it isn't perfectly straight.^[nine]

4. 4

   Use the angled brush to push this paint up to the line. Don't put any more than paint on the brush before you do this. Merely push the paint until the tips of the castor come up to the line, then stop.^[10]

   • If the other side of the line hasn't been painted notwithstanding, it's fine if y'all accidentally go over the line in a few places.

5. 5

   Paint left and right in a shine motion to straighten out the line. Use slow and fifty-fifty strokes to straighten out the paint as necessary. Be certain to utilise only the tips of the brush; this will meliorate ensure your line is equally directly as possible.^[11]

   • Doing this will create a smooth, direct line of paint along the line that you marked earlier.

6. 6

   Repeat this process on the other side of the line if needed. Rinse your angled brush under running water to get the paint off of information technology. Then, apply your second color to the beard and echo the process of applying, pushing, and straightening the paint to the reverse side of the line.

   Advertisement

1. one

   Apply a pencil and ruler to mark where your line volition be, if necessary. For example, y'all'll need to marker where yous desire your line to exist if you're trying to paint stripes on a wall. Repeatedly run the pencil along the ruler where you want your line to be, marking 12 inches (xxx cm) at a time, until you've drawn the unabridged line you lot desire to paint against.^[12]

   • For best results, use a bubble level as yous go to make sure you're cartoon a direct line.
   • Feel free to skip this step if you're trying to paint betwixt the wall and the ceiling.

2. 2

   Paint the surface of the edger to utilize paint to it. This will help you control the amount of paint you want to apply with the edger and continue yous from accidentally putting besides much on it. Employ a regular paint castor to apply the pigment to the edger.

   • This is specially of import if your edger has wheels on it, since dipping the edger into your paint will well-nigh definitely get pigment on these wheels.

3. three

   Run the edger along the edge of the line. If the edger has wheels, place the wheels right against the surface of the ceiling or the wall to make the line as straight equally possible. If it doesn't have wheels, run the edger as slowly and smoothly equally possible to ensure your line is straight.^[thirteen]

   • It's ok if some of the paint goes over the line, as long as you haven't painted the opposite side of the line yet.
   • Information technology's too fine if y'all're non able to get all the mode up to the ceiling because of the edger's wheels; you can touch on up these spots with a small brush subsequently.

4. 4

   Bear on up whatever unpainted spots, equally needed. Employ a small castor to finish applying paint in any spots forth the line that the edger wasn't able to get. For best results, use an angled brush with short, small bristles.^[14]

5. v

   Utilize a wet cloth to wipe off any pigment that went over the line, if needed. This is of import if you were painting a line confronting something that yous didn't want to paint, such as a window sill. You can likewise use disinfectant wipes to clean up any accidental drips or smudges.^[15]

   Advert

Add New Question

• Question

  How practice you get a straight line when you lot're painting?

  

  Andres Matheu is the Possessor of Hömm Certified Painting Systems, an Interior and Exterior Residential painting business based in the Washington, DC Metro surface area. Andres specializes in interior and outside residential painting, color consultations, cabinet refinishing, wallpaper removal, and epoxy flooring among other services. An EPA Lead-safe Certified Firm, Hömm Certified Painting Systems has been awarded the All-time of Houzz 2022 Service, Angie's List Super Service Award 2019, and Northern Virginia Mag'due south 2022 All-time Home Experts (painters) award.

  

  Commercial Painter

  Expert Reply

Ask a Question

200 characters left

Include your electronic mail address to get a bulletin when this question is answered.

Submit

Advert

• If you're painting forth an area that already has a straight line, like a door frame, merely utilise that as your guide and pigment along it carefully with an angled brush.^[xvi]

Advertisement

Things You'll Need

• Paint castor
• Painter's tape
• Angled castor
• Edger
• Pigment

About This Article

Thanks to all authors for creating a page that has been read 44,551 times.

Did this article help you?

coiltwessight.blogspot.com

Source: https://www.wikihow.com/Paint-Straight-Lines

Share this post